Raspberry Pi LoRa/GPS HAT - 868MHz

Raspberry Pi LoRa/GPS HAT - 868MHz
Raspberry Pi LoRa/GPS HAT - 868MHz
Raspberry Pi LoRa/GPS HAT - 868MHz
Raspberry Pi LoRa/GPS HAT - 868MHz
Raspberry Pi LoRa/GPS HAT - 868MHz
Raspberry Pi LoRa/GPS HAT - 868MHz
Raspberry Pi LoRa/GPS HAT - 868MHz
Raspberry Pi LoRa/GPS HAT - 868MHz
Raspberry Pi LoRa/GPS HAT - 868MHz
Raspberry Pi LoRa/GPS HAT - 868MHz
Raspberry Pi LoRa/GPS HAT - 868MHz
Raspberry Pi LoRa/GPS HAT - 868MHz

Omschrijving

De Dragino LoRa/GPS HAT is een uitbreidingsmodule voor LoRaWAN en GPS gebruik voor de Raspberry Pi. Dit product is bedoeld voor mensen die geïnteresseerd zijn in het developen van LoRaWAN solutions.

De LoRa/GPS HAT is gebaseerd op de SX1276/SX1278 transceiver. De toegevoegde L80 GPS(gebaseerd op MTK MT3339) is gemaakt voor applicaties die GPS koppelen via de seriële poorten aan de Raspberry Pi zoals timing applicaties of algemene applicaties die om GPS informatie vragen.

De transceivers van de LoRa/GPS HAT hebben de LoRa long range modem dat ultra lange afstand spectrum communicatie biedt en hoog onderbrekingsimmuniteit terwijl deze stroomverbruik verminderen. De LoRa/GPD HAT kan gevoeligheid behalen van meer dan -148dBm met het gebruik van een betaalbare crystal en andere materialen. De hoge sensitiviteit in combinatie met de geïntegreerde +20 dBm stroomversterker maakt het optimaal voor elke applicatie die vraagt om afstand of robuustheid. LoRa biedt ook significante voordelen in beide het blokkeren en de selectiviteit over andere modulation technieken waardoor hij het compromis tussen afstand, onderbreking immuniteit en energieconsumptie oplost.

Dit board kan automatisch banen berekenen met het gebruik van de ephemeris data (tot 3 dagen) die opgeslagen wordt in de interne flash memory. Met de AlwaysLocate technologie kan de LoRa/GPS HAT de on/off time aanpassen om de balans te behalen tussen nauwkeurigheid en stroomconsumptie volgens de omgeving- en bewegingscondities. De GPS ondersteunt ook een automatische antenne schakelfunctie.

Features

  • Frequency Band: 868 MHZ/433 MHZ/915 MHZ(Pre-configure in factory)
  • Compatible with Raspberry Pi 2 Model B/Raspberry Pi 3.
  • LoRa™ Modem
  • FSK, GFSK, MSK, GMSK, LoRa™and OOK modulation
  • Preamble detection
  • Baud rate configurable
  • Built-in temperature sensor and low battery indicator
  • Excellent blocking immunity
  • Automatic RF Sense and CAD with ultra-fast AFC
  • Support DGPS, SBAS(WAAS/EGNOS/MSAS/GAGAN)
  • GPS automatic switching between internal patch antenna and external active antenna
  • PPS VS. NMEA can be used in time service
  • Support SDK command
  • Built-in LNA for better sensitivity
  • EASY™, advanced AGPS technology without external memory
  • AlwaysLocate™, an intelligent controller of periodic mode
  • GPS FLP mode, about 50% power consumption of normal mode
  • GPS support short circuit protection and antenna detection

Specificaties

Lora Specs

  • 168 dB maximum link budget.
  • +20 dBm - 100 mW constant RF output vs. +14 dBm high efficiency PA.
  • Programmable bit rate up to 300 kbps.
  • High sensitivity: down to -148 dBm.
  • Bullet-proof front end: IIP3 = -12.5 dBm.
  • Excellent blocking immunity.
  • Low RX current of 10.3 mA, 200 nA register retention.
  • Fully integrated synthesizer with a resolution of 61 Hz.
  • FSK, GFSK, MSK, GMSK, LoRa™ and OOK modulation.
  • Built-in bit synchronizer for clock recovery.
  • Preamble detection.
  • 127 dB Dynamic Range RSSI.
  • Automatic RF Sense and CAD with ultra-fast AFC.
  • Packet engine up to 256 bytes with CRC.
  • Built-in temperature sensor and low battery indicator.

GPS Specs

  • Power Acquisition: 25mA,Power Tracking:20mA.
  • Compliant with GPS, SBAS.
  • Programmable bit rate up to 300 kbps.
  • Serial Interfaces UART: Adjustable 4800~115200 bps,Default: 9600bps.
  • Update rate:1Hz (Default), up to10Hz.
  • Protocols:NMEA 0183,PMTK.
  • Horizontal Position Accuracy:Autonomous<2.5 m CEP.
  • TTFF@-130dBm with EASY™:Cold Start<15s,Warm Start <5s,Hot start <1s;TTFF@-130dBm.
  • without EASY™:Cold Start<35s,Warm Start <30s,Hot Start <1s.
  • Timing Accuracy:1PPS out 10ns,Reacquisition Time<1s.
  • Velocity Accuracy Without aid<0.1m/s,Acceleration Accuracy Without aid 0.1m/s².
  • Sensitivity Acquisition -148dBm,Tracking -165dBm,Reacquisition -160dBm.
  • Dynamic Performance Altitude Max.18000m,Maximum Velocity Max.515m/s,Maximum Acceleration 4G.
  • L1 Band Receiver(1575.42MHz) Channel 22 (Tracking) /66 (Acquisition).

Onderdelen

  • 1x Lora/GPS HAT
  • 4x Brass cylinders
  • 4x Screws
  • 4x Nuts
  • 1x Glue Stick Antenna(868 MHZ)

Reviews

Verlanglijst Raspberry Pi LoRa/GPS HAT - 868MHz
Productcode: SS-113990254
€ 31,82
Excl. BTW
Dit product is niet op voorraad
Dit artikel is momenteel niet beschikbaar voor backorder.
  • Verzonden vanaf € 8,91 naar Verenigde Staten
  • 30 dagen niet goed, geld terug
  • Snelle levering vanuit Nederland

Specificaties

Algemeen
ProductcodeSS-113990254
MerkSeeed Studio
EAN841454118749
MPN113990254
PlatformRaspberry Pi (ARM)
Geschikt voorRaspberry Pi 4

Misschien vind je deze ook interessant

De Grove – LoRa Radio 868MHz module heeft een RFM95 transceiver met LoRa modem die ultra lange afstand spread spectrum communicatie en hoog onderbrekingsimmuniteit heeft terwijl deze het stroomverbruik minimaliseert.
€ 15,66 Excl. BTW
De Dragino LoRa Shield is een lange afstandstransciever op een Arduino shield en gebaseerd op Open source library. Het LoRa shield laat de gebruiker data versturen en extreem lange afstanden behalen op lage data rates.
€ 22,27 Excl. BTW
WM1302 Pi HAT is een Raspberry Pi uitbreidingskaart voor het aansluiten van de WM1302 LoRaWAN module, gebaseerd op de LoRa Concentrator Semtech SX1302.
€ 19,79 Excl. BTW
Snelle verzending
Voor 17.00 uur besteld (ma-vr), is zelfde dag verzonden.
Niet goed, geld terug
Bij ons heb je een zichttermijn van 30 dagen.
Wereldwijde verzending
Wij verzenden vanuit Nederland met PostNL en DHL.
Thuiswinkel.org Lid