USB to RS232 cable

Using the FT232R chip combined with an RS232 level converter and a few capacitors, the UC232R-10 ChiPi is a CE and FCC approved product which is one of the simplest USB to RS232 solutions around. Using a standard DB9 connector and powered from the USB port, the UC232R-10 ChiPi converter can be used with FTDI's VCP drivers to provide a COM port on a PC which is capable of communication rates with RS232 devices from 300baud up to 230kBaud. This version of the UC232R-10 is supplied with a nicely sculpted matte white plastic enclosure fitted, which covers the electronics inside. A 10cm USB cable is fitted.

Features

• FT232RL provides single chip USB to asynchronous serial data transfer interface
• Entire USB protocol handled on the FT232RL chip. No USB specific firmware programming required
• Fully assisted hardware or X-On / X-Off software handshaking
• Royalty free VCP and D2XX drivers eliminate the requirement for USB driver development in most cases
• Converter cable supply voltage comes from VCC, no external supply required
• FT232RL has integrated USB resistors
• USB bulk transfer mode
• Low USB bandwidth consumption
• UHCI / OHCI / EHCI host controller compatible
• USB 2.0 full speed compatible