Unity V2 HAT Case for RPi 5

The Unity V2 HAT case for Raspberry Pi 5 is made of cast acrylic and is produced in-house with our laser cutting machine. The case is matte black with a transparent top and can accommodate HATs and other expansions that have no protruding parts, such as for example the M.2 HAT+, Sense HAT or the NVMe expansion from 52Pi.

By using 16mm spacers between the Pi and the HAT, the Active Cooler (not included) can be placed for ventilation. Warm air is blown out through the rear vent.

Features

• Made of cast acrylic
• Includes spacers for mounting HATs
• Power button remains accessible
• microSD can be replaced without disassembling the case
• Cutout for flex cables for camera and/or display
• Can be mounted to the wall

This case is slightly higher (41 mm) than the standard Unity V2 case (33 mm), to make room for HATs. For mounting, you only need a small Phillips screwdriver.

Suitable HATs and extensions

The following products have been tested with this case. The list is not exhaustive.

• M.2 HAT+ for Raspberry Pi 5
• Sense HAT (stacking header required)
• N04 M.2 2280 PCIe to NVMe Top Expansion for Raspberry Pi 5 (remove front panel)

Notes

• The GPIO header is not accessible from outside the enclosure.
• Shown HATs are for illustration purposes only