Standalone Toggle Capacitive Touch Sensor Breakout - AT42QT1012

Standalone Toggle Capacitive Touch Sensor Breakout - AT42QT1012
Standalone Toggle Capacitive Touch Sensor Breakout - AT42QT1012
Standalone Toggle Capacitive Touch Sensor Breakout - AT42QT1012
Standalone Toggle Capacitive Touch Sensor Breakout - AT42QT1012
Standalone Toggle Capacitive Touch Sensor Breakout - AT42QT1012
Standalone Toggle Capacitive Touch Sensor Breakout - AT42QT1012
Standalone Toggle Capacitive Touch Sensor Breakout - AT42QT1012
Standalone Toggle Capacitive Touch Sensor Breakout - AT42QT1012
Standalone Toggle Capacitive Touch Sensor Breakout - AT42QT1012
Standalone Toggle Capacitive Touch Sensor Breakout - AT42QT1012

Description

This breakout board is the simplest way to create a project with a single "toggle" capacitive touch sensor. No microcontroller is required here - just power with 1.8 to 5.5VDC and touch the pad to activate the sensor.

This sensor is a toggle output type: touch-on then touch-off. That means that when a capacitive load is detected (e.g. a person touches the sensor-pad area) the red LED will alternate turning off and the output pin will go high or low, respectively. This sensor is good for a project where you want to activate something on the first touch, then deactivate it when touching again, like a switch. You can also solder a wire to the middle pad and create your own capacitive pad if the built-in one isn't suited to your project.

If you want to save power, the LED can be disconnected from the output pin (cut the trace between the jumper marked as such). We designed this breakout to have infinite time-out. The chip does support having the sensor time-out, so for example, if something is turned on, it will eventually turn off on its own. If you'd like to use this mode, cut the TIMER jumper and then connect a resistor/capacitor to the TIME pin. Check the datasheet for how to calculate the TIME pin to match your desired timeout.

Comes with a fully assembled board, and a small stick of 0.1" header so you can solder and plug it into a breadboard. For additional contacts, we suggest using copper foil, then solder a wire that connects from the foil pad to the breakout.

Reviews

Standalone Toggle Capacitive Touch Sensor Breakout - AT42QT1012
Product Code: ADA-1375
€ 5.29
Ex. VAT
10 or more € 5.03 Ea. (-5%)
This product is out of stock
  • Shipping from € 61.57 to United States
  • 30 days money back guarantee
  • Fast shipping from The Netherlands

Specifications

General
Product CodeADA-1375
BrandAdafruit
MPNP1375
Technical
Input Voltage1.8 ~ 5.5 VDC
Other
Dimensions20 x 29.35mm 2.03g

You might like these as well

Add lots of touch sensors to your next microcontroller project with this easy-to-use 8-channel capacitive touch sensor breakout board, starring the CA..
€ 7.79 Ex. VAT
This breakout board is the simplest way to create a project with a single "momentary" capacitive touch sensor. No microcontroller is require..
€ 5.49 Ex. VAT
This breakout board is the simplest way to create a project with multiple capacitive touch sensors. No microcontroller is required here, just power wi..
€ 7.19 Ex. VAT
Fast shipping
Order before 17:00h (Mon-Fri) for same day shipping.
Money back guarantee
You have a 30-day return period on your order
Worldwide shipping
Shipped from the Netherlands using PostNL and DHL.
Thuiswinkel.org Lid