Menu
Your cart

Arduino MKR WAN 1300 with uFL connector

Product Code: ARD-ABX00017
Arduino MKR WAN 1300 with uFL connector
Arduino MKR WAN 1300 with uFL connector
Arduino MKR WAN 1300 with uFL connector
Arduino MKR WAN 1300 with uFL connector
Arduino MKR WAN 1300 with uFL connector
Arduino MKR WAN 1300 with uFL connector
Arduino MKR WAN 1300 with uFL connector
€ 42.50
Incl. 21% VAT
€ 35.12 Ex. VAT
1 piece(s) directly available from stock.
Shipped on Monday when ordered now.
QuantityDiscountPrice
10 or more-3%€ 41.22 Ea.
50 or more-6%€ 39.95 Ea.

Description

Arduino MKR WAN 1300 has been designed to offer a practical and cost effective solution for makers seeking to add Lo-Ra connectivity to their projects with minimal previous experience in networking. It is based on the Atmel SAMD21 and a Murata  CMWX1ZZABZ Lo-Ra module.

The design includes the ability to power the board using two 1.5V AA or AAA batteries or external 5V. Switching from one source to the other is done automatically. A good 32 bit computational power similar to the MKR ZERO board, the usual rich set of I/O interfaces, low power Lo-Ra communication and the ease of use of the Arduino Software (IDE) for code development and programming. All these features make this board the preferred choice for the emerging IoT battery-powered projects in a compact form factor. The USB port can be used to supply power (5V) to the board. The Arduino MKR WAN 1300 is able to run with or without the batteries connected and has limited power consumption.

Warning: Unlike most Arduino & Genuino boards, the MKR WAN 1300 runs at 3.3V. The maximum voltage that the I/O pins can tolerate is 3.3V. Applying voltages higher than 3.3V to any I/O pin could damage the board. While output to 5V digital devices is possible, bidirectional communication with 5V devices needs proper level shifting.

Specificaties

MicrocontrollerSAMD21 Cortex-M0+ 32bit low power ARM MCU
Board Power Supply (USB/VIN)5V
Supported Batteries(*)2x AA or AAA
Circuit Operating Voltage3.3V
Digital I/O Pins8
PWM Pins12 (0, 1, 2, 3, 4, 5, 6, 7, 8, 10, A3 - or 18 -, A4 -or 19)
UART1
SPI1
I2C1
Analog Input Pins7 (ADC 8/10/12 bit)
Analog Output Pins1 (DAC 10 bit)
External Interrupts8 (0, 1, 4, 5, 6, 7, 8, A1 -or 16-, A2 - or 17)
DC Current per I/O Pin7 mA
Flash Memory256 KB
SRAM32 KB
EEPROMno
Clock Speed32.768 kHz (RTC), 48 MHz
LED_BUILTIN6
Full-Speed USB Device and embedded Host 
Antenna power2dB
Carrier frequency433/868/915 MHz
Working regionEU/US
Length67.64 mm
Width25 mm
Weight32 gr.

Specifications

General
Product CodeARD-ABX00017
BrandArduino
EAN813747020558
MPNABX00017
PlatformArduino

Reviews

Write a review

Please login or register to review