Menu
Your cart

Batteryholders

In Stock: In Stock Product Code: KW-2820
This battery holder with JST plug is suitable for 2x AA batteries and has a convenient on/off switch...
In Stock: In Stock Product Code: KW-2151
This 3x AAA battery holder has 15cm leads with a JST connector.Dimensions are 52.5mm x 37.5mm x 12mm...
9V Batterij clip naar 2.1mm DC plug 9V Batterij clip naar 2.1mm DC plug
Out Of Stock
Product Code: KW-1555
 A 9V battery clip with DC barrel jack connection (5.5 * 2.1mm)With this connector you can, for example, run your Arduino on a 9-volt battery...
In Stock: In Stock Product Code: KW-2540
Battery holder for 18650 BatterySpecifications Leads: cables     Cell size: MR18650     Number of batteries: 1     Colour: black     Cable length: 150mmDatasheet..
In Stock: In Stock Product Code: KW-2381
Power your project with this handy battery holder for two CR2032 button cells. There is an on/off switch at the top, and the wire length is approximately 15 cm.SpecificationsWeight: 5g (11g including batteries) Dimensions: 53 x 23 x 6 mm Output: 6V 220mAhBatteries not included!..
In Stock: In Stock Product Code: KW-1642
This battery holder offers space for 3x AAA batteries in series, perfect for powering different projects. This particular holder has an on/off switch and is suitable for 3.3V projects which require a 2-pin JST-PH 2.0 connector for e.g. Li-Ion/Poly batteries.Note:When using rechargeable Ni..
In Stock: In Stock Product Code: KW-1539
Make a nice portable power pack with this 4 x AA battery holder. It fits any alkaline or rechargeable AA batteries in series. There's a snap on cover and an on/off switch which can be handy when wiring to something without a switch.The four batteries are held in series, for a nominal output ..
In Stock: In Stock Product Code: KW-1538
Make a portable power brick with plenty of juice! Use Alkaline AA's for a 9V 3000-4000mAh power supply, or rechargeable NiMH for 2000mAh 7.5V supply. Either one is good for running electronics that have a 5V voltage regulator (thus requiring a 7V+ supply). Will last about 10 times longer than a ..
In Stock: In Stock Product Code: KW-1537
When you need a portable 12V power pack, this big holder will do the job! The holder will store 8 AA batteries end to end, to give approximately 12VDC output with up to 2 amp peak current draw. This configuration holds the batteries securely, even if being bumped/moved around...
In Stock: In Stock Product Code: ADA-653
This battery holder is by far the easiest way to add a battery to a small wearable project. By coincidence, there are two small 1mm diameter holes in the metal connection tabs, just large enough for a #5 or smaller needle to pass through. One tab connects to common ground (negative) and the other ta..
In Stock: In Stock Product Code: ADA-770
Keep your power source safe and toasty in these waterproof 2xAA battery holders. They're just like classic switched battery holders, but designed for survival! The case has a rubber gasket around the edge of the case (its black and hard to see in the photos but it is there) and attaches together..
Showing 1 to 12 of 13 (2 Pages)