Your shopping cart is empty
All Products
This 4-wire cable is a little over 200mm long and fitted with JST-SH female 4-pin connectors on both ends.
This breakout board contains the LIS3MDL three-axis magnetometer and can be used with either I2C or SPI.
Add lots of touch sensors to your next microcontroller project with this easy-to-use 12-channel capacitive touch sensor breakout board, starring the MPR121.
STEMMA QT / Qwiic cable with micro test hooks for I²C connection without soldering, ideal for prototyping.
Grove - Qwiic Hub allows you to either use Qwiic/STEMMA QT modules on Grove controller or use Grove modules on Qwiic/STEMMA QT controller.
This miniature GPS breakout is only 25mm x 25mm but houses a complete GPS/GNSS solution with both I2C and UART interfaces.
USB to GPIO, ADC (10-bit), DAC (5-bit), and I2C bridge with STEMMA QT/Qwiic, USB-C, 4 GPIO, and clock output for quick prototyping.
Small blue 4-digit display including a backback with the necessary electronics (HT16K33) pre-assembled and tested to drive the LED segments.
Do you want to connect multiple Grove, Qwiic, and STEMMA QT modules to your development boards using a single cable? Look no further!
The Adafruit LC709203F LiPoly / LiIon Fuel Gauge and Battery Monitor can be used to monitor your batteries. Connect it to your Lipoly or LiIon battery and it will let you know the voltage of the cell, it does the annoying math of decoding the non-linear v