The Raspberry Pi Camera Module 2 can be used to take high-definition videos and photos. The camera is easy to use, but also has a lot to offer advanced users, such as time-lapse, slow-motion and other smart video features.The camera supports 1080p30, 720p60 and VGA90 video modes and can also tak..
The 1 Wire Pi Plus from AB Electronics UK is a communication board supporting the 1-Wire® protocol designed for use on the Raspberry Pi. A 5V buffered I2C port is also provided on the board. The 1 Wire Pi Plus can be securely fitted to your Raspberry Pi using the mounting kit pack.
The 1 Wire Pi Zero from AB Electronics UK is a communication board supporting the 1-Wire® protocol designed for use on the Raspberry Pi Zero. A 5V buffered I2C port is also provided on the board. The 1 Wire Pi Zero can be securely fitted to your Raspberry Pi using the mounting ki..
This is a 3.5 inch LCD display which fits right onto the GPIO header of the Raspberry Pi. Ideal to create a small touch interface for example.Features480x320 hardware resolution
Resistive touch control
Supports any type of Raspberry Pi
Drivers provided (works with your own Raspbian/..
This is a 4-channel current and power monitor HAT designed for the Raspberry Pi. Via the I2C or SMBus interface, it's easy to monitor each channel's current, voltage and power consumption, as well as the voltage between both sides of the sampling resistor.FeaturesStandard Raspberr..
Features800x480 high hardware resolution
Resistive touch control
IPS technology, high quality and perfect displaying from very wide viewing angle
Compatible and Direct-connect with any revision of Raspberry Pi (except the Pi 1 model B or Pi Zero, which requires an HDMI cable)
This is an E-Ink display HAT for Raspberry Pi, 7.5inch, 800x480 resolution, with embedded controller, communicating via SPI interface.Due to the advantages like ultra low power consumption, wide viewing angle, clear display without electricity, it is an ideal choice for applications such as shel..
This is an 7.5inch E-Ink display HAT for your Raspberry Pi/Jetson Nano/Arduino with a 800x480 resolution, embedded controller and communicatiion via SPI.Due to the advantages like ultra low power consumption, wide viewing angle and clear display without electricity, it's an ideal choice for ..
This is an E-Ink display HAT for the Raspberry Pi, 9.7inch, 1200x825 resolution, with embedded controller IT8951, communicating via USB/SPI/I80 interface, supports partial refresh.Due to the advantages like ultra low power consumption, wide viewing angle, clear display without electricity, it is..
This ADS1015 ADC (analog-to-digital converter) breakout has three channels that can read voltages from -24V to +24V at sampling rates up to 3.3KHz with 12-bit resolution.It's Raspberry Pi and Arduino-compatible, and ideal for measuring DC voltages quickly and precisely over a wide range..
This DRV2605L haptic driver breakout with linear actuator will really get you buzzing! The powerful haptic buzz (bzzz!) is programmable with a range of built-in patterns, or you can program your own. This little haptic driver and actuator is great for adding some buzzy feedback to your projects..
A Raspberry Pi mini HAT designed to help you take care of your plants. It can tell you how well they're hydrated, attract your attention when they need water and, if you want to go a step further, even give them water!Please note that this listing is for the Grow HAT Mini HAT only. You'l..