Analog Feedback Micro Servo - Plastic Gear

A custom-make  classic 'micro' sized hobby servos with a twist - the feedback (potentiometer wiper) line is brought out to a fourth white wire. You can read this wire with an analog input such as those on an Arduino, to get the servo's position. That information can be used in robotics to improve stability or even allow 'recording' of servo motion.

Note !

The default servo pulse widths (usually 1ms to 2ms) may not give you a full 180 degrees of motion. In that case, check if you can set your servo controller to custom pulse lengths and try 0.75ms to 2.25ms. You can try shorter/longer pulses but be aware that if you go too far you could break your servo!

Specifications

• Dimensions: 11.57mm x 22.75mm x 29.45mm
• Max Dimensions: 11.57mm x 32.71mm x 31.76mm
• Wire length (at least): 13cm long
• Torque: 1.6 kg*cm @ 6V
• Speed: 0.1 sec/60° @ 6V
• Weight: 13.82 grams
• Dual ball bearing
• Plastic gearbox
• Spline Count: 22