Adafruit Perma-Proto HAT for Raspberry Pi Mini Kit - Without EEPROM

Design your own Pi HAT, attach custom circuitry and otherwise dress your Raspberry Pi with this jaunty prototyping HAT kit

It has a grid of 0.1" prototyping soldering holes for attaching chips, resistors, LED, potentiometers and more. The holes are connected underneath with traces to mimic the solderless breadboards you're familiar. There's also long power strips for +3V, +5V and Ground connections to the Pi. Near the top nearly every pin you could want to connect to the Pi is broken out (#26 didnt quite make the cut).

This is just the basic version of the Perma-Proto HAT.  It comes with a printed circuit board and a single 2x20 GPIO Header for Raspberry Pi to put your Perma-Proto on top of your Raspberry Pi (like a nice little hat...) This version does not come with an EEPROM so you can 'stack' it with other HATs without worrying about an EEPROM address collision.

Note

without EEPROM

A bit of light soldering is required to attach the header

This HAT is only compatible with the Raspberry Pi boards with 2x20 headers.