7 inch DSI Touch Display - 1280x800 - RPi only

This 7 inch DSI display is designed to be used with the Raspberry Pi(except the Zero, please click here for a 7-inch Zero display).

Mount your Raspberry Pi to the back of the display, connect the correct flat cable(when used with a Pi 5, connect to the dsi1 port) and you're almost ready to go. Please check this wiki page for the correct settings(depends on the Pi used), extra software options and useful tips.

Just add the following data to your config file and you're ready to go:

dtoverlay=vc4-kms-v3d
#DSI1 Use
dtoverlay=vc4-kms-dsi-waveshare-panel,8_0_inch
#DSI0 Use
#dtoverlay=vc4-kms-dsi-waveshare-panel,8_0_inch,dsi0

Features

• 7inch DSI touch screen, supports ten-point capacitive touch control
• Wide color gamut IPS display panel, hardware resolution of 1280×800, color gamut of 68% NTSC
• Optical bonding toughened glass panel, clearer picture quality
• Equipped with 6H hardness tempered glass touch cover
• Compatible with Raspberry Pi 5/4B/CM4/3B+/3A+/3B/CM3+/CM3
• Directly drive the LCD through the Raspberry Pi's DSI interface, with a refresh rate of up to 60Hz
• When used with Raspberry Pi, it is compatible with Bookworm/Bullseye/Buster systems
• Supports software to adjust the brightness of the backlight

Contents

• DSI display
• 3 DSI cables
• 4-pin power cable(for usage with CM4)
• Screws and standoffs